Malfunction
|
Its reasons
|
Your help
|
A.Stseplenie slips |
1. Coupling overlays are worn out 2. Too insignificant clamping pressure of coupling 3. The overlay was made oily 4. Coupling перегрето |
Replace a conducted disk Replace press a coupling disk Replace a conducted disk and a defective lining of a transmission or коленвала Replace defective details |
V.Stseplenie is not disconnected |
1. Air in hydraulic system of coupling 2. In a conducted disk a dent 3. The conducted disk is deformed or the overlay has broken 4. The conducted disk gets jammed on a transmission shaft 5. An overlay after long standing приржавела to a flywheel
6. Tangential sheet springs of a press disk are broken
|
Replace a defective detail, remove air from system Will correct a conducted disk or replace Replace a conducted disk Carefully clean a teeth a wire brush. Then grease with paste Moly or a spray. Put 1st transfer and turn a starter to get the engine. All time hold pressed a coupling pedal. Sharply press a pedal of gas and release it to tear off coupling. Otherwise dismantle. Replace press a disk
|
S.Stseplenie is not switched off and simultaneously slips |
Defect in a press disk of coupling |
Replace press a coupling disk |
D. Coupling twitches |
1. Defect in the engine or in a transmission suspension bracket 2. Roughnesses in an adjoining surface of a flywheel or a press disk 3. Improper overlays |
Replace engine or transmission bearings Replace a defective detail Replace a conducted disk
|
E.Shumy in coupling
|
1. A disbalance of a press or conducted disk of coupling 2. Defective торсионная демпфирующая a spring 3. Defective выжимной the bearing 4. Are weakened заклепочные connections in coupling 5. The defective needle bearing behind in коленвале |
Replace press or a conducted disk of coupling Replace a conducted disk Replace выжимной the bearing Replace press a coupling disk
Replace the needle bearing
|