Infringements in system ABS work
At ignition inclusion control bulb ABS on a control panel flashes. It should go out, when the engine will earn, or most later at the speed which has exceeded 6 km/h. If onboard pressure falls more low 10 In the control bulb also lights up. It can light up and in the event that one of wheels slips longer 20 with. Then again switch off ignition and anew start the engine.
If the bulb burns constantly, ABS is not ready for operation. In workshop Audi or Bosch should define the reason. As the fan you can check up anyway штекерные sockets of the block of management, gauges of number of turns or the hydraulic module. Besides, it is possible to recommend to disconnect gauges of number of turns and to clean their front party.
|
|
Council: Even if control bulb ABS burns constantly, i.e. ABS does not work, you should conduct the car taking into account idle system of electronic distribution of brake effort. Brakes of back wheels can be blocked rather early. Extra care is required on turns where at Audi with the blocked back brakes can bring a back part. Cautiously driving the car, find workshop Audi. |
|