Audi А4
+ Running gear
+ Regular servicing
+ Engines
+ Turbo-supercharging
+ Exhaust system
+ Cooling system
+ Fuel tank and the fuel pump
+ The air filter and channels всасывания
+ Injection system
+ Coupling
+ Transmission and the main transfer
+ Suspension bracket of wheels and steering
+ Brakes
+ Wheels and tyres
+ The electrotechnical equipment
+ Ignition system
+ Illumination
+ The alarm equipment
+ Tools and devices
+ Heating and ventilation
- Body details
Forward bumper
Damages to result of failures
Face-to-face part of the car
Cowl
Wings
Lateral laths
Doors
Dismantling of doors
Mirror of the external review
Luggage carrier cover
Back bumper
Sliding/demountable roof
Check of a corrosion-resistant coating of the bottom
Procleaning of apertures for a water drain
+ Salon
Search of malfunctions
Technical characteristics
|
Forward bumper
|
|
After easing of the screw (3) it is possible to extend a detail of a lattice (2) of lateral штекерных connections (arrow). On a fixing bolt of a bumper the key with internal шестигранником 6 mm (1) is established. |
|
|
To take out lateral faces of a bumper from body arms, it is necessary to wring out in the beginning a bumper downwards and then to pull aside. |
Dismantle
|
|
- Dismantle the bottom facing of an impellent compartment.
- Unscrew on one screw with crosswise heads in small details of a lattice on the right and at the left below in a bumper. Take out from clips a lattice and remove it.
- Under lattice details is on one bolt with шестигранной a head on 6 mm. Unscrew.
- Unscrew behind at a bumper in cut for a wheel on the right and at the left on one bolt TORX.
- Take out lateral faces of a bumper from an arm on a wing. For this purpose wring out a bumper sideways downwards and simultaneously pull it from a body.
- Wring out the bumper ends over bowls of wheel niches and remove forward.
- Now it is possible to pull a bumper forward.
- Cars with system of clarification of headlights: remove hoses to sprays and supply with their stoppers that contents of a tank of washing have not flowed out.
- The spoiler can be removed below at a bumper after dismantle распорных ledges on a socket on the right and at the left.
|
|
Installation
|
|
- Connect water hoses.
- In the beginning lift a bumper on arms.
- Now enter bumper lateral faces so that its ends did not concern bowls of a wheel niche.
- In the beginning a bumper hang on a bottom edge of arms on a wing. Then press a bumper from sides; the upper edge as a result of it will enter into grooves.
- Tighten bolts.
|
|
Bumper alignment
|
|
- After bumper installation check up, whether the crack between headlights and a bumper is identical everywhere.
- But crucial importance has a crack between a bottom edge of a cowl and a bumper (about 7 mm).
- If the crack does not correspond to norm, again dismantle a bumper and slightly turn upwards or downwards the carving plug in a bumper arm.
|
|
|
|
