Audi А4
+ Running gear
+ Regular servicing
+ Engines
+ Turbo-supercharging
+ Exhaust system
+ Cooling system
+ Fuel tank and the fuel pump
+ The air filter and channels всасывания
+ Injection system
+ Coupling
+ Transmission and the main transfer
+ Suspension bracket of wheels and steering
+ Brakes
+ Wheels and tyres
+ The electrotechnical equipment
+ Ignition system
+ Illumination
+ The alarm equipment
+ Tools and devices
+ Heating and ventilation
- Body details
Forward bumper
Damages to result of failures
Face-to-face part of the car
Cowl
Wings
Lateral laths
Doors
Dismantling of doors
Mirror of the external review
Luggage carrier cover
Back bumper
Sliding/demountable roof
Check of a corrosion-resistant coating of the bottom
Procleaning of apertures for a water drain
+ Salon
Search of malfunctions
Technical characteristics
|
Wings
Arrangement of fixing elements of a forward wing (6)
|
|
In drawing two fixing bolts of a wing (1 and 2) which are accessible at an open lobby of a door are shown. |
Forward wings unscrew. On the contrary, back lateral details are strongly welded – there is no field for activity of the fan.
Dismantle подкрылков a wheel niche
|
|
- Remove a corresponding forward wheel.
- Hang out a lateral face of a bumper from an arm on a wing. For this purpose wring out a bumper below on height of an arm and simultaneously pull from a body.
- Loosen the all fixing screws подкрылка a wheel niche.
- Turn to the left on 90 a high-speed shutter of connection with the bottom facing of the engine.
- Remove подкрылок a wheel niche with распорных fingers and wring out inside from cut for a wheel.
- At installation softly tighten screws, differently in plastic the carving will be broken!
|
|
Wing dismantle
|
|
- Dismantle подкрылок a wheel niche.
- Dismantle a bumper.
- Dismantle the turn index.
- On a wing bottom edge unscrew ahead one and behind two screws with crosswise heads or bolts TORX.
- Under cut for the turn index unscrew a bolt, the second – ahead in cut for a wheel.
- Unscrew behind in a wheel niche facing (closing detail). For this purpose ослабьте two bolts.
- Now both bolts on a fixing crosspiece of metal behind on a wing are accessible – unscrew.
- Open a forward door – unscrew a bolt over hinges.
- Unscrew bolts with шестигранными heads on a wing upper edge.
- Remove a wing.
- At installation adjust a crack in relation to a cowl at even weakened top fixing bolts of a wing. It should be about 3,0 mm.
|
|
|
|