Audi A4

Since 1994 of release

Repair and car operation


Audi А4
+ Running gear
+ Regular servicing
+ Engines
+ Turbo-supercharging
+ Exhaust system
+ Cooling system
+ Fuel tank and the fuel pump
+ The air filter and channels всасывания
+ Injection system
+ Coupling
+ Transmission and the main transfer
+ Suspension bracket of wheels and steering
+ Brakes
+ Wheels and tyres
+ The electrotechnical equipment
+ Ignition system
+ Illumination
+ The alarm equipment
+ Tools and devices
+ Heating and ventilation
- Body details
   Forward bumper
   Damages to result of failures
   Face-to-face part of the car
   Cowl
   Wings
   Lateral laths
   Doors
   Dismantling of doors
   Mirror of the external review
   Luggage carrier cover
   Back bumper
   Sliding/demountable roof
   Check of a corrosion-resistant coating of the bottom
   Procleaning of apertures for a water drain
+ Salon
Search of malfunctions
Technical characteristics









Mirror of the external review

Mirror dismantle in gathering

1 – the fixing screw;
2 – a shaped detail from polyfoam for a noise isolation;

3 – многоштырьковый a socket.


Dismantle of mirror glass (4)

1 – black facing below under a mirror;
2 – facing screws;

3 – a servomotor.
By arrows clamps on mirror glass are shown.

Dismantle of the case (1) mirrors

2 – a mirror arm;
3 – a servomotor;

4 – mirror glass.
By arrows screws with which the mirror case to an arm fastens are shown.

Replacement of mirror glass

Mirror glasses in mirrors Audi А4 fasten only spring clips. Dismantle:

 PERFORMANCE ORDER

  1. Loosen the below on a mirror both screws with crosswise heads also remove black facing.
  2. Shift thus facing aside to take out clamps.
  3. Put on working gloves if is сколы.
  4. Through an aperture in the bottom of a mirror it is possible to reach about several clamps with which mirror glass to a servomotor fastens.
  5. Accessible clamps take out from grooves a screw-driver – then it is possible to wring out glass completely.
  6. Disconnect a socket of heating of a mirror.
  7. At installation insert mirror glass into frictional springs on the case. Establish glass on a ring of a servomotor and press so that it has entered into clamps.
  8. Press the middle of glass and again put on gloves.

Dismantle of the case of a mirror

 PERFORMANCE ORDER

  1. Dismantle mirror glass.
  2. Unscrew a servomotor and remove.
  3. Unscrew three screws and remove the case from an arm upwards.

Mirror dismantle in gathering

 PERFORMANCE ORDER

  1. Wring out from within the black decorative triangular panel in a triangle of forward lateral glass.
  2. Disconnect многоштырьковый a socket.
  3. Unscrew the fixing screw of a leg of a mirror.
  4. Remove a mirror in gathering.

 Council: the Information on functioning and check of adjustment of a mirror with the electric drive you will find Tools and devices in the head.