Filling and system prorolling сервоуправления
The control system is filled in and pumped over in the event that separate knots of hydraulic system have been replaced and consequently it was necessary to merge hydraulic oil.
|
|
- Clean the filter in a tank промывочным gasoline.
- Fill in new hydraulic oil to a mark "MOVE". The churned butter do not use.
- Prop up a forward part of the car from two parties and at the switched off engine of 10 times slowly turn a wheel from an emphasis against the stop.
- Add hydraulic oil to a mark "MOVE".
- Start the engine and again turn a wheel of 10 times from an emphasis against the stop.
- If liquid level falls, put wheels directly and add a liquid while level will constantly not keep on a mark "MOVE". At wheel rotation in a tank air vials any more should not rise.
- Check up level of a liquid after a short trip.
|
|
|